Kinco Logo
 
 

Kinco Servo FD432S-LA-000

  • -CANopen communication
  • -Main Supply Voltage: AC220V -20/+15% 47-63Hz
  • -Rated current is 11A , Peak current is 27.5A
  • -Rated Output Power (KW): 0.2-2.3KW
 

Technical Specifications

Main supply voltageSingle-phase or 3-phase AC220V -20/+15% 47~63Hz
Control circuit voltage18VDC~30VDC 1A
Rated current(RMS)10A
Peak current(PEAK)27.5A
Feedback signal2500PPR (incremental encoder with 5V supply)
Multi-turn 16 bits communication absolute encoder
Sigle coil 20 bits communicarion encoder
Brake chopperUse an external braking resistor according to application, mainly in occasion of quick stop
Brake chopper thresholdDC380V±5V
Over-voltage alarming thresholdDC400V±5V
Under-voltage alarming thresholdDC200V±5V
Cooling methodFan
Weight(Kg)2.4
Digital input specification7 digital inputs, with COMI terminal for PNP (high level valid 12.5-30V) or NPN (low level valid) connection.
Digital input functionDefine freely according to requirement, supporting following functions: Driver enable,driver fault reset,driver mode control, proportional control, positive limit, negetive limit, homing signal,reverse command, internal speed section control, internal positive section control, quick stop, start homing, active command, switch electronic gear ratio, switch gain
Digital output specification5 digital outputs,OUT1~OUT4 current is 100mA, BR+/BR- (Brake control ourtput ) current is 500mA, can drive brake device directly
Digital output functionDefine freely according to requirement, supporting following functions: Driver ready, driver fault, position reached, motor at zero speed, motor brake, motor speed reached, Z signal, maximum speed obtained in torque mode, motor brake, position limiting, reference found, multi-position reached.
Analog input2 analog input, can be used to control speed and torque, the input range is -10V~10V.Output encoder signal is optional, can be used in the multiple axises synchronization, the max.
Encoder signal output functionOutput encoder signal is optional, can be used in the multiple axises synchronization, the max. output frequency is 2MHz
RS232The max. baudrate is 115.2KHz, use JD-PC software to communicate with PC, or via free protocol to communicate with controller.
Protection functionsOver-voltage protection,under-voltage protection,motor over-heat protection(IT),short-circuit protection,drive over-heat protection,etc.
RS485The max. baudrate is 115.2KHz, use Modbus RTU protocol to communicate with controller.
Operating temperature0~40℃
Storage temperature-10℃~70℃
Humidity(non-condensing)Below 90%RH
Protection classIP20
Installation environmentInstalled in a dust-free,dry and lockable environment(such as in a electrical cabinet)
Installation modeVertical installation
HeightNo power limitation below 1000m
Atmospheric pressure86kpa~106kpa

Mechanical Dimension Diagram

下载失败

 
 

Easy Solution

 
Facebook GooglePlus
 

tel
Sales:

+86 755 26585555-345

Technical:

+86 755 26585555-337

 
 
Copyright © 2015 Kinco Automation